DOD Flashback Fuzz FX66 Effect Pedal

Description

DOD Flashback Fuzz FX66 Effect Pedal
- Mint Condition
- Original Box & Manual Included
- 9v Power supply not included
What the FX66 Does
The FX66 is a distortion pedal reminiscent of the old fuzzy faced distortions of the 60’s.Y ou’ll feel like you’ve had a flashback from the Monterey Pop Festival just by connecting your guitar to the FX66 and playing.
Connecting The FX66
Connect your guitar to the input of the FX66. Connect the output of the FX66 to the input of your amplifier (or to the input of another effect device you may be running).To eliminate the need for a 9 volt battery, connect the PS200R to the AC power jack on the FX66.
Features
• LEDitching for noisy compartment.
• Adapter
Features
• LED indicator shows status of effect and battery condition.
• Active switching for noiseless operation. • Easy access battery compartment.
• Adapter jack for AC operation.
• Rugged die-cast metal chassis.
• Three year limited warranty. • Rubber non-skid bottom.
Controls
Volume -
This knob adjusts the overall volume level of the FX66.
Low -
This knob adjusts the amount of low frequen- cies in your guitar tone.
Tone -
This knob adjusts the amount of high fre- quencies in your guitar tone.
Fuzz -
This knob adjusts the amount of distortion produced.
Footswitch -
Bypasses, and re-engages the distor- tion.
LED Indicator -
Lights when the distortion is active and is not lit when the distortion is bypassed.
Jacks -
Input, Output, AC adapter (use only the PS200R).
Operation of the FX66
The FX66 was designed to give you the vintage sound typical of what bands in the 60’s used. A few simple knob adjustments and the groovy tones will make you feel the flower power. You’ll find yourself saying “peace, love and rock & roll, man.”
Start by adjusting the Volume knob to match the level of the bypassed signal. Bypass the FX66 and lis- ten to the volume level.Then engage the distortion and turn the Volume knob until the level is relatively the same.
Next, you’ll want to tune in the amount of Fuzz that you need. Rotate the Fuzz knob until you find that psychedelic groove you’re looking for.
Now use the Low control to adjust how heavy you want the bass frequencies to be.
Finally, use the tone knob to give your guitar the amount of high end edge that you want.
Don’t be afraid to experiment with different knob settings.After all, only you know the colors that you want your music to show. It’s now up to you to “tune in, turn on and drop out.”
Important Notes
• The FX66 battery is in use whenever you are plugged into the INPUT jack.To extend the life of the battery, be sure to disconnect the input when the FX66 is not in use.
• Remove the battery when the FX66 will not be used for an extended period of time.This will pre- vent possible damage due to leaking battery fluids.
• Battery replacement is indicated when the FX66 fails to switch in and out, or when the LED stays lit.
• Keeping the battery in the FX66 while using an AC adapter will provide continuous operation in the event of a power failure.
• Use of any power adapter other than the PS200R will void the warranty of this product.
• No user serviceable parts inside. Removal of the bottom plate will void the warranty of this prod- uct. Should your FX66 require servicing, contact your authorized DOD dealer for return/repair information.